To Open And Close Solenoid Valve/Burner; Light/Dimmer Operation; Circulating Fan Operation; Modes Of Operation - Maxitrol GV60 Installation And Operating Instructions Manual

OPERATING INSTRUCTIONS

TO OPEN AND CLOSE SOLENOID VALVE/BURNER

NOTE: The latching solenoid valve cannot operate manu-
ally. If the battery runs down it will remain in the last
operating position. During normal operation the sole-
noid valve will be reset to the ON position when the
GV60 is switched OFF remotely.
8SRQ LJQLWLRQ 0DLQ %XUQHU DQG 'HFRUDWLYH
Burner are ON.
6LPXOWDQHRXVO\ SUHVV SET and
ÀDPH EXWWRQV WR VZLWFK WKH %XUQHU 2))
Printed instructions are on the battery cover
VHH ¿JXUH  
6LPXOWDQHRXVO\ SUHVV SET and
ÀDPH EXWWRQV WR VZLWFK %XUQHU 21 7KH
AUX symbol on the display indicates the so-
Burner OFF
lenoid valve is OPEN.)
NOTE: The operation of the AUX is blocked
in timer OFF mode, when the setting
of the
ture is "
Burner ON
Figure 23: Instructions for Latching Solenoid Valve (on battery cover)

LIGHT/DIMMER OPERATION

Light/Dimmer
%ULHÀ\ SUHVV 6(7 EXWWRQ WR VFUROO WR
EXOE PRGH /LJKW EXOE LFRQ ÀDVKHV
3UHVV DQG KROG
turn ON the light or increase brightness.
3UHVV DQG KROG
crease brightness.
,Q WKH /LJKW'LPPHU PRGH WKH 2)) EXWWRQ
shuts OFF the light.
,I \RX ZDQW WKH OLJKW 21 EXW QR ÀDPH SUHVV
and hold the
WR 3LORW ÀDPH
NOTE: The light bulb icon is displayed during light/dim-
mer setting only. 8 seconds after the light/dimmer
has been set, the handset will automatically go into
temperature control mode (CSA version) or manual
mode (CE version).
(small
(large
Nighttime Setback Tempera-
".
(light
ODUJH ÀDPH EXWWRQ WR
VPDOO ÀDPH EXWWRQ WR GH-
VPDOO ÀDPH EXWWRQ DQG WXUQ

CIRCULATING FAN OPERATION

Circulating Fan
The circulating fan has 4 speed levels from low (1 bar) to
high (4 bars).
%ULHÀ\ SUHVV 6(7 EXWWRQ WR VFUROO WR
IDQ PRGH )DQ DQG /HYHO LFRQV ÀDVK
3UHVV
and increase fan speed.
3UHVV
fan speed.
7R WXUQ 2)) IDQ SUHVV
ton until all 4 speed level bars disappear.
NOTE: 8 seconds after the fan has been set, the handset
will automatically go into temperature control mode
(CSA version) or manual mode (CE version). The
fan starts 4 minutes after the gas opens (from OFF
or from pilot) at maximum speed and goes to the
displayed level after 10 seconds. The fan stops 10
minutes after the gas is OFF or at pilot.

MODES OF OPERATION

%ULHÀ\ SUHVVLQJ WKH 6(7 EXWWRQ FKDQJHV WKH
mode of operation in the following order:
MAN
TIMER
NOTE: Manual mode can also be reached by pressing either
the ODUJH ÀDPH RU WKH
MAN
0DQXDO ÀDPH KHLJKW DGMXVWPHQW
TEMP
(Appliance must be in standby mode; pilot
ignited)
The room temperature is measured and
compared to the set temperature. The
ÀDPH KHLJKW LV WKHQ DXWRPDWLFDOO\ DGMXVWHG
to achieve the Daytime Set Temperature.
Light/Dimmer Setting Mode
Turns light/dimmer ON and OFF and ad-
justs brightness.
17 / 84
FOR OEM USE ONLY
ODUJH ÀDPH EXWWRQ WR VZLWFK 21
VPDOO ÀDPH EXWWRQ WR GHFUHDVH
VPDOO ÀDPH EXW-
TEMP
DQG EDFN WR .
MAN
VPDOO ÀDPH EXWWRQ
Manual Mode
Daytime Temperature Mode
TEMP