Operating Instructions; General Notes; Setting The Electronic Code - Maxitrol GV60 Installation And Operating Instructions Manual

OPERATING INSTRUCTIONS

Temperature
ON/OFF Temperatures setting (page 18)
Program timer setting (page 19)
Fan operation (page 17)
Modes of operation (page 17)
Figure 19

GENERAL NOTES

Radio Frequency Handset
433.92 MHz for Europe; 315 MHz for U.S. and for Canada.
This device complies with part 15 of the FCC Rules. Op-
eration is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This
device must accept any interference received, including in-
terference that may cause undesired operation. Changes or
PRGL¿FDWLRQV QRW H[SUHVVO\ DSSURYHG E\ WKH SDUW\ UHVSRQ-
sible for compliance could void the user's authority to oper-
DWH WKH HTXLSPHQW
NOTICE
Wiring of valve and receiver must be completed before start-
ing ignition. Failure to do so could damage the electronics.
Batteries – Handset
 [ 9 DONDOLQH UHFRPPHQGHG 
/RZ EDWWHU\ LQGLFDWRU RQ KDQGVHWV ZLWK GLVSOD\
+DQGVHWV ZLWKRXW GLVSOD\ WKH UHG /(' JHWV GDUNHU
%DWWHU\ UHSODFHPHQW LV UHFRPPHQGHG DIWHU  \HDUV
Batteries – Receiver
 [  9 ³$$´ DONDOLQH UHFRPPHQGHG 
/RZ EDWWHU\ LQGLFDWLRQ IUHTXHQW EHHSV IRU  VHFRQGV ZKHQ
motor turns.
$Q $& 0DLQV $GDSWHU PD\ EH XVHG LQVWHDG RI EDWWHULHV
7KH PRGXOH IRU IDQ VSHHG FRQWURO DQG OLJKWGLPPHU LQ-
cludes mains power together with batteries in the receiver
for automatic backup in case of power outage.
:LWKRXW XVLQJ D PDLQV DGDSWHU EDWWHU\ UHSODFHPHQW LV UHF-
ommended at the beginning of each heating season.
NOTICE
Only the Mertik Maxitrol AC Mains Adapter or one pre-
approved by Mertik Maxitrol can be used. Use of other
adaptors can render the system inoperable.
NOTICE
The handsets, receivers, wall switches, switch panels and
touchpads are not interchangeable with previous electron-
LFV VHH ¿JXUH  
°C/24 hour or °F/12 hour Clock
setting (page 18)
Signal indicator
NOTICE
Replacement handsets for CSA models also must have
the same part number (see label).
SETTING THE ELECTRONICS CODE
(First time use only.)
Radio Frequency Handset
A code is selected automatically for all Mertik Maxitrol elec-
tronics from among 65,000 random codes available.The re-
ceiver has to learn the code of the handset:
3UHVV DQG KROG WKH UHFHLYHU¶V UHVHW EXWWRQ VHH ¿JXUH 
XQWLO \RX KHDU WZR  EHHSV 7KH ¿UVW EHHS LV VKRUW DQG WKH
second beep is long. After the second beep, release the
reset button.
:LWKLQ WKH VXEVHTXHQW  VHFRQGV SUHVV WKH
ÀDPH EXWWRQ RQ WKH KDQGVHW XQWLO \RX KHDU WZR DGGLWLRQDO
VKRUW EHHSV FRQ¿UPLQJ WKH FRGH LV VHW ,I \RX KHDU RQH ORQJ
EHHS WKLV LQGLFDWHV WKH FRGH OHDUQLQJ VHTXHQFH KDV IDLOHG
or the wiring is incorrect.
NOTE: 7KLV LV D RQH WLPH VHWWLQJ RQO\ DQG LV QRW UHTXLUHG DI-
ter changing the batteries of the handset or receiver.
Figure 21: Receiver Reset Button
15 / 84
FOR OEM USE ONLY
Battery status
Time setting (page 18)
Light/Dimmer operation (page 17)
Solenoid Valve/Burner
OPEN and CLOSE (page 17)
Fan level icon (page 17)
Figure 20: Previous Handset
(small