Install The Drive; Required Tools For Installing The Drive - ABB ACS560 Quick Installation And Start-Up Manual

Install the drive

You can install the drive
• to a DIN installation rail with integrated lock. This method applies to frames R0...R2
only.
or
• with screws to a suitable surface (wall or assembly plate). This method applies to all
frames R0...R8.
￭

Required tools for installing the drive

• A drill and suitable drill bits.
• Screwdriver (Flat head, Phillips head, and Torx)
• wrench with suitable bits and sizes (appropriate for the installation hardware used). See
the required screw sizes in below installation instructions
• A tape measure and spirit level.
• Personal protective equipment.
￭ Installing a drive to DIN installation rail (frames R0...R2 only)
1. On the top center of the drive move the locking part to the left.
2. Push and hold the locking button down.
3. Put the top tabs on the drive onto the top edge of the DIN rail.
4. Put the drive against the bottom edge of the DIN installation rail.
5. Release the locking button.
6. Move the locking part to the right.
7. Make sure the drive is installed correctly.
￭ Removing drive from the DIN installation rail (frames R0...R2 only)
To remove the drive, open the locking part using a flat-head screwdriver.
EN - Quick installation and start-up guide 5
EN
HI