ABB ACS560 Quick Installation And Start-Up Manual page 6

6 EN - Quick installation and start-up guide
￭ Installing a drive with screws (frames R0...R8)
All drives of frames R0...R8 can be installed on a wall with screws. See the required screw
sizes in below mounting dimensions table. See also
requirements (page 103)
WARNING!
The drive module (frames R6...R8) is heavy (45 to 70 kg). Consider the following:
• Use a suitable lifting device.
• Do not lift the module manually.
• Make sure that the wall and the fixing devices can carry the weight. See data
in the table below.
EN
1. Mark the mounting hole locations using the mounting template included in the package.
HI
Mounting template
1
2. Drill the mounting holes.
3. Tighten the screws into the mounting holes.
4. Position the drive onto the screws on the wall.
5. Tighten the mounting screws.
2
Dimensions, weights and free space
Mounting dimensions
Frames R0 R1 R2
Screws M5
(mm)
a 191
b -
50 75 148
d 75
e 75
Weight 4.47 4.57 7.54
(kg)
3
R3 R4 R5 R6
M6 M8
473 619 581 531
612 571
160 213
-
200
14.86 23.0 28.0 45.0
4
5
R7 R8
583 658
623 701
245 263
55.0 70.0