ABB ACS560 Quick Installation And Start-Up Manual page 21

M5×25/35
Frame size L1, L2, L3, T1/U, T2/V, T3/W
R5
R6
R7
R8
Terminals T1/U, T2/V and T3/W
• Remove the nut attached to the connector and its busbar.
• Put the conductor under the connector pressure plate and pre-tighten the conductor.
• Put the connector back to its busbar. Start the nut, and turn it by hand to at least two
rotations.
Before using tools, make sure that the nut/screw is not cross-threaded.
Cross-threading damages the drive and causes danger.
• Tighten the nut to a torque of 30 N·m (22 lbf·ft).
• Tighten the conductor(s) to 40 N·m (30 lbf·ft) for frame R8 or to 70 N·m (52 lbf·ft) for
frame R8.
Terminals L1, L2 and L3
• Remove the combi screw attached to the connector and to its terminal post, and pull
the connector off.
• Put the conductor under the connector pressure plate and pre-tighten the conductor.
• Put the connector back onto the terminal post. Start the combi screw, and turn it by
hand to at least two rotations.
Before using tools, make sure that the nut/screw is not cross-threaded.
Cross-threading can damage the drive and cause danger.
• Tighten the combi screw to a torque of 30 N·m (22 lbf·ft).
• Tighten the conductor(s) to 40 N·m (30 lbf·ft) for frame R8 or to 70 N·m (52 lbf·ft) for
frame R8.
9b
9a
8
N·m lbf·ft
5.6 4.1
30 22.1
40 29.5
40 29.5
EN - Quick installation and start-up guide 21
10b
10a
8
PE
N·m lbf·ft N·m
2.2 1.6
9.8 7.2
9.8 7.2
9.8 7.2
EN
HI
lbf·ft
1.2 0.9
1.2 0.9
1.2 0.9
1.2 0.9