Extron electronics ACP 106 D Setup Manual

ACP 106 D • Setup Guide
The Extron ACP 106 D Audio Control Panel is a fully configurable control interface for use with any Extron ACP-enabled device.
Each ACP 106 D includes two ACP ports, which support power and communication between the host device and the ACP 106 D.
Up to eight ACP panels can be used per host device for more demanding control needs.
Front Panel Features
B
MUTE
A
G G
X
D
VOLUME
C
P
E
MIC
F
PROGRAM
Extron Extron
Mute Buttons
A
Transmit LED
B
Volume Buttons
C
Volume LED Meter
D
Function Button 1
E
Function Button 2
F
Figure 1. ACP 106 D Rear Panel
Planning the System and Installation
When planning to install an ACP system, consider how many ACP panels to use, maximum cable distance, and mounting (see the
ACP 106 D product page at
Installation
Step 1: Get Ready
Use the following checklist to prepare for the installation:
…
Download and install the latest version of software, firmware, and device drivers needed to configure the host device and
configure the connected ACP products (see the host device user guide, available on www.extron.com, for details on
software and drivers).
…
Obtain cables, mounting hardware, and any other supplies required for ACP 106 D installation.
Rear Panel Features
www.extron.com for more information about the ACP 106 D).
A A
B B
ACP Ports (2)
A
Connection Status LED
B
Reset Button
C
Bus ID DIP Switches
D
Figure 2. ACP 106 D Front Panel
D D
1