Service Schedule - CYBEX SPARC Owner's Manual

4. Insert the two battery access cover tabs into console.
5. Tighten the battery access cover screw using a flat head screwdriver.
NOTE: Dispose of batteries safely after replacement or before unit disposal.

Service Schedule

All maintenance activities shall be performed by qualified personnel. Failure to do so could result in serious injury.
This is the minimum recommended service.
Determine distance
1. Verify foot plates are completely stopped.
2. Grasp handrail and step carefully onto foot plates.
3. Press and hold the Up
4. Navigate in the Toolbox menu to STATS with the Down
5. Press the GO/Enter key to enter STATS.
1. The TOTAL ON TIME and TOTAL RUN TIME is displayed on the STATS screen.
The time is displayed as ###:##:## (Days:Hours:Minutes).
NOTE: A Day is recorded as 24 hours of use. It is not days used or days since installation.
6. Record the TOTAL RUN TIME.
7. Press the GO/Enter key to go BACK to the toolbox menu.
8. Press the Down arrow to select EXIT in the setup menu.
9. Press the GO/Enter key to exit Toolbox.
Daily Procedures
See detailed procedures in
1. Clean console
2. Clean base.
Every 6 Months
The TOTAL RUN TIME for 6 months is approximately 6 days.
1. Move unit and vacuum underneath. Lift the rear of unit and roll it back from its present position. Vacuum underneath and return
unit to normal position.
2. Check battery level.
arrow and Down arrow for 3 seconds.
Clean Unit section.
Item
1
2
3
arrow.
Page 32 of 36
Description
Console
Battery access cover
Tabs
Qty.
1
1
2