Testing Operation - CYBEX SPARC Owner's Manual

3. Press the GO/Enter key to enter DIAGNOSTICS.
4. Push the resistance lever forwards to the highest resistance level.
5. Press and hold the Up
6. Pull the resistance lever backwards to the lowest resistance level.
7. Press and hold the Down
8. Press the GO/Enter key to go BACK to the toolbox menu.
9. Press the Down arrow to select EXIT in the setup menu.
10. Press the GO/Enter key to exit Toolbox.
Diagnostics menu
ARC TRAINER
PRESSURE/TEMP
BRAKE VALUE
BATTERY

Testing Operation

Use the following instructions to test the full resistance and incline range of the unit:
1. Grasp handle on incline lever and depress the plunger.
arrow for three seconds until the BRAKE VALUE section blinks. The upper value is stored.
arrow for three seconds until the BRAKE VALUE section blinks. The lower value is stored.
Software revision number.
Pressure: Displays Barometric pressure in HPA (hectopascal).
Temperature : Displays local temperature in degrees Celsius.
Displays brake position value. Range is P1 to P10.
Displays battery level from 0 to 100% in 10% increments. LOW BATTERY screen will be
displayed at 10%.
Item
1
2
3
Page 19 of 36
Description
Plunger
Handle
Incline lever
Qty.
1
1
1