Ventilation Position - RADEMACHER DuoFern Instruction Manual

i

15.4 Ventilation position

If you do not want the roller shutter to close fully to the lower end point,
you can use this function to configure an arbitrary position
(e.g. as the ventilation position).
When closing automatically, the roller shutter stops at the ventilation
position, but it can subsequently be fully closed manually.
i
1.
i
2.
3.
92
The run time must be configured prior to setting the venti-
lation position, see page 94.
Select the desired function
using the multidirectional toggle switch.
The subsequent setting of the ventilation position is only
possible when the ventilation function is activated.
Open the pop-up window for the ventilation
position.
You can move to the desired ventilation
position by pressing and holding the
up / down button.
The position reached is displayed after
releasing the up / down button. This can be
accepted with the OK button or re-adjusted
with the up / down button.
EN