Condair MD Series Commissioning Manual page 4

Water additives
Contains water Chlorine?
Chlorine no
Chlor. yes
Display appears only when "Water
Supply" is set to "Rev. osm."
Determine whether or not there is
chlorine in the supply water.
Drain Mode
Fill Cycles
Condu.
Autodrain
Set the drain mode type and confirm.
With installed "WT option": "Condu."
With "Tap water": "Autodrain"
For more information on drain modes,
see the installation and commissioning
manual.
4. Compare the set unit variant under "Menu > Info > System Info> System type" with details on the type plate in the "Code"
field:
Condair Group AG, Gwatttrasse 17, 8808 Pfäffikon SZ, Switzerland
Type: Condair MD-EL-H
Voltage: 230V/1~/ 50-60Hz
Humidifier capacity: 2 kg/h
Water pressure: 1.5..5bar,<30°C
Engineered in Switzerland, Made in Germany
If the unit variant does not match the specification on the type plate, please contact the Condair Support.
4
Heating System
Floor
Electrical
Others
Enter the heating type of the humidifier
water and confirm.
– "Floor": Variant MD-FB-H
– "Electrical": Variant MD-EL-H
– "Others": Variants MD-HW-H, MD-
WW-H
Leakage Floor
Off
On
Activate optional floor leak sensor and
confirm.
Serial-No: XXXXXXX 11.19
El. Power: 800.0 VA 3.4 A
Code: MD-EL-H
Descale Interval
Calculated descale
intervall is too short.
A water treatment is
required. Please
repeat installation.
Display appears only when "Water
Supply" is set to "Tap water" and the
calculated decalcification interval is too
short, which means that the optional
water treatment available from Condair
must be used. The device can not run
in the set configuration.
Confirm message. The installation
routine returns to setting the water
supply type.
Installation
All necessary values have
been provided. Yor are all
set. Thank you.
Installation routine completed. Confirm
message.
Code Unit variant
EL 2 Condair MD-EL-H
FB Condair MD-FB-H
FB + 1HE Condair MD-FB-H with additional el. heating element
HW Condair MD-HW-H
WW Condair MD-WW-H