Condair MD Series Commissioning Manual page 10

3. Under "Menu > User Settings > Humidity Level", set the "High" parameter back to 50% and set the desired humidification
intensity on the home screen.
Humidity Level
Low
Mid
High
4. Switch off hydraulic unit. Attach housing cover and lock. Switch on the hydraulic unit again.
WARNING!
Guarantee of hygienic operation
After initial commissioning, the Condair MD must not be switched off and must be operated either in the operating
mode "Humidity" (humidity required) or "Standby" (no humidity required). This is the only way to ensure that the
water system will flush periodically and that there is no microbial contamination of the system by stagnant water.
5. Important: Enter system data in the corresponding field in the table below:
Installation date (MM/DD/YYYY):
Initial commisioning date (MM/DD/YYYY):
Installation site:
Model:
Serial number:
Cartridge size of water treatment device:
Setting bypass level of water treatment device:
Water hardness of water supply at the installation site:
pH value of water supply at the installation site:
10
Condair MD
40%rH
45%rH
50%rH