Graco e-Xtreme Z25 Operation - Repair - Parts page 7

5. Attach ground wire to ground terminal inside
junction box (S).
NOTE: The power cord attaches to a separate
ground screw than the ground screw that is already
attached.
6. Place fan wires and other power wires into open
area on either side of disconnect block (J) as space
permits. Reinstall junction box cover. See F
If wires get pinched when the screws are tightened,
damage will occur. Make sure all wires are routed
correctly before installation.
G
E
F . 5: Grounding Wire
IG
333208F
NOTICE
J
7. Replace junction box screws and washers removed
in step 2 and tighten cord grip to securely hold
power cord in junction box (S). See F
F . 6: Junction Box Screws and Strain Relief
IG
. 5.
IG
Installation
. 6.
IG
S
7