AudioCodes Mediant 1000 Hardware Installation Manual page 73

And e-sbc

Hide thumbs Also See for Mediant 1000:

Table of Contents

CHAPTER 6 Hardware Maintenance

Remove the blank-panel slot cover from the slot intended for the HDMX module, by

gently pulling on the handle of the module until it slides out of the slot.

Hold the HDMX module in the correct orientation, as shown in the following figure,

and gently insert the module into the slot, sliding it along the slot's guide rails until it

makes contact with the card-edge connector located on the backplane.

Push the module's handle until it clicks firmly into the slot.

Install the OSN Module:

Remove the blank-panel slot cover from the slot intended for the OSN module, by

gently pulling on the handle of the module until it slides out of the slot.

Hold the OSN module in the correct orientation, as shown in the following figure, and

gently insert the module into the slot, sliding it along the slot's guide rails until it makes

contact with the card-edge connector located on the backplane.

Figure 6-12: Inserting HDMX Module into Slot

Figure 6-13: Inserting OSN Module into Slot

Mediant 1000 Gateway & E-SBC | Hardware Installation Manual

- 65 -

Table of Contents