AudioCodes Mediant 1000 Hardware Installation Manual page 28

CHAPTER 3 Physical Description
Item #
The RJ-45 connector pinouts for the Gigabit Ethernet interface are listed in the following table:
Table 3-15: RJ-45 Connector Pinouts for Gigabit Ethernet Interface
Pin
1
2
3
4
5
6
7
8
LED Description
The OSN4B module LEDs are shown in the following figure and described in the subsequent
table.
Label
● LED #2: On (solid red)
✔ End of reset: LED #1 remains on (solid green); all other LEDs
off.
■ To cold (hard) reset the OSN server (i.e., powers off and then
powers on): Press the button for longer than five seconds and
then release. The LED indications are as follows (see LED
Description for LED locations):
Upon reset:
✔
● LED #1: On (solid green)
● LED #2: On (solid red)
● LED #5: On (solid blue)
✔ End of reset: LED #1 remains on (solid green); all other LEDs
off.
100Base-Tx
I/O
O
0
I
I
Mediant 1000 Gateway & E-SBC | Hardware Installation Manual
Description
Signal Signal
Tx+ I/O
Tx- I/O
Rx+ I/O
I/O
I/O
Rx- I/O
I/O
I/O
- 20 -
1000Base-T
Function
BI_DA+
BI_DA-
BI_DB+
BI_DC+
BI_DC-
BI_DB-
BI_DD+
BI_DD-