AudioCodes Mediant 1000 Hardware Installation Manual page 52

CHAPTER 5 Cabling the Device
●
●
The analog Lifeline is provided only by Port I on an FXS module. This port connects to the POTS
phone and the PSTN or PBX, using a splitter cable. The splitter cable connects pins 1 and 4 to
another source of an FXS port, and pins 2 and 3 to the POTS phone, as shown in the following
figure:
Cabling specifications:
Cable: Splitter cable adaptor with RJ-11 on one end and two RJ-11 jacks on the other
■
■ Connector: RJ-11
Connector Pinouts:
■
➢ To cable the analog Lifeline:
1. Connect the RJ-11 connector on one end of the Splitter cable (supplied) to Port I on the FXS
module.
2. Connect the Lifeline POTS phone using an RJ-11 connector cable to Port A on the Lifeline
Splitter.
3. Connect an analog PSTN line using an RJ-11 connector cable to Port B on the Lifeline
Splitter.
Analog Lifeline is supported only on FXS modules.
An analog Lifeline can be setup for each FXS module installed in the chassis.
Figure 5-12: RJ-11 Connector Pinouts for Analog Lifeline
Mediant 1000 Gateway & E-SBC | Hardware Installation Manual
- 44 -