Lubrication Point On Spindle; Cleaning Full Bag Sensor; Cleaning High Dumpc; Unit Identification & T - Kioti WD1260 Operator's Manual

L P
UBRICATION OINT ON
C F B
LEANING ULL AG
To ensure proper function of the Full Bag Sensor
operator must regularly clean the sensor tunnel by
removing the rod shown in Figure 13-2 and clean the
end to allow proper air flow.
C H D
LEANING IGH UMP
Release the upper metal mesh located inside the
grass collector by pressing the pin on each side. Then
you can recline the mesh in order to clean it.
S B
PINDLE EARINGS
Figure 13-1
S T
ENSOR UNNEL
Figure 13-2
C

OLLECTOR

Figure 13-3
U I
NIT DENTIFICATION
Each lawn mower is delivered with a manufacturer's
label which indicates model, serial number, and year of
production. These numbers are necessary when
ordering parts or contacting an authorized dealer for
service or parts. For safety and to ensure high quality,
only OEM or factory certified spare parts should be
used on your mower.
Warranty is provided as stated in the warranty
literature provided with your unit. Both engine and
battery are covered by the warranty provided by their
respective manufacturer.
S P
ERVICE OSITION
Place unit on a flat level surface. ALWAYS stop engine
and disengage PTO. Assure unit is secure and will not
tip over. Strap and clamp onto lift if used. Open hood
to access battery or engine.
C S
HECK AFETY
Check safety interlock system before every use. See
SAFETY INTERLOCK SYSTEM Section.
DO NOT operate unit unless safety interlock system is
functioning properly. If it is not functioning properly,
contact your equipment dealer.
C F
HECK ASTENERS
Be certain that all hardware is tightened to the proper
torque. Pay special attention to the blades, guards and
safety shields.
E
LECTROMAGNETIC
Engagement via the electromagnetic clutch of the
mowing deck, hydraulic power pack, or the front PTO
shaft. When the clutch is worn (when the clutch
disengagement is prolonged) it is necessary to contact
your authorized service center for assistance in order
to extend the life of the electromagnetic clutch.
F A :
RONT XLE
37
& T S
ECHNICAL
I S
NTERLOCK

YSTEM

C
LUTCH
Figure 13-4
ERVICE