Rear Panel Interlocks; Moving The Unit Manually; Shut Off; Parking - Kioti WD1260 Operator's Manual

To Empty the High Dump System Collector:
Figure 10-5
1. When lifting and dumping the collector, the
operator must sit on the seat of the mower and the
mower engine must be running.
2. Move the mower in reverse with caution and low
speed to within 1 m of side of the transport vehicle
or container.
3. Using the Hydraulic Control Lever (#1 in Figure
10-5) lift the collector until the top of the collector is
turned 180 degrees and is facing down as shown
in picture below. This is the maximum lift height
and will provide maximum clearance.
4. Carefully back up the machine so that the gap
between the lift arms and the upper edge of the
transport vehicle or container is 10 to 15 cm.
5. Use the Lever (#1) to tip the collector and dump
the grass into the transport vehicle or container.
6. Return the collector to the position shown in
picture below.
7. Move the machine forward to a safe distance away
from the side of the transport vehicle or container.
8. Completely lower the collector using the Hydraulic
Control Lever (#1).
9. Return the Steering/Lifting Selector Valve to the
Steering position.
10. Drive the machine back to the desired location and
resume mowing.
Important Note: When the Hydraulic Control Lever is
pulled to the Lift position, the hydraulic power steering
will not be engaged. Expect that extra force will be
required if you attempt to turn the steering wheel under
these conditions.
R
The PTO clutch will not engage if the Interlock Switch
on the rear panel is not depressed. Never attempt to
bypass this switch electrically or mechanically. Use
only attachments approved by Wisconsin Engineering.
Keep the switch covers free of debris. Accumulated
debris may cause problems and limit proper operation
of switch.
1 M
IMPORTANT: DO NOT push or pull (tow) tractor with
another vehicle. Transmission damage will occur.
1. Engage the parking brake and stop engine.
2. Disengage transmission using bypass control on
3. Release parking brake.
4. Push unit to desired location.
5. Apply parking brake and engage transmission.
S
Emergency Shut-Off
To shut-off unit in an emergency, turn ignition key to
the off position.
Normal Shut-Off
1. Remove foot from forward or reverse pedal.
2. Disengage PTO.
3. Lower attachment and engage parking brake.
4. Move throttle lever to slow position. Let engine run
5. Turn ignition key to the OFF position and remove
P
To engage parking brake:
1. Stop machine on a level surface. Do not park on a
2. Disengage PTO.
3. Lower attachments to the ground.
4. Lock park brake.
5. Stop engine.
6. Remove key from ignition switch.
7. Before you leave the operator's station, wait for
S
Never exceed 10 degree slope. Use extreme caution
when operating on any uneven ground.
30
P I
EAR ANEL NTERLOCK
U M
OVING THE NIT ANUALLY
pump
O
HUT FF
a few minutes so engine parts cool evenly before
shutting engine off.
key.
ARKING
slope.
engine and all moving parts to stop.
LOPES
S

WITCH