Install Dispersion Hood; Fuel; Install Front Counter; Weight - Kioti WD1260 Operator's Manual

I D
NSTALL ISPERSION
The Dispersion Hood is installed following these steps:
Remove the High Dump
System by following the
1.
installation steps in
reverse order
Attach the Standard
2. Collector Brackets on both
sides
Attach the Dispersion
3. Hood to the Brackets on
both sides
Remove the Interlock
4. Switch from the High
Dump Collector.
Install the Interlock Switch
5. in the lower position as for
the Standard Collector
Disconnect the Interlock
6.
Switch wires
Connect the wires to the
7.
Interlock Switch.
Use the Dispersion hood
in accordance with the
8.
operating instructions in
this manual.
H
OOD
9
IMPORTANT: Grass container or dispersing hood
depresses a switch (9), which blocks the
electromagnetic clutch from engaging the blades when
neither the grass container or dispersing hood is
mounted on the machine. Do not remove this switch
from the machine or limit the performance of this
security device. Check and clean the switch from
grass and debris occasionally during operation.
F
UEL
The fuel tank holds approximately 20 liters of diesel
fuel. Fuel gauge is located under the seat. To add
fuel, follow instructions in Operating section.
CAUTION! Avoid fire. Wipe away any
spilt fuel or oil immediately! Use extra care
when handling fuels. They are extremely
flammable, the vapors can be explosive, and
they can burn skin and eyes. Allow the
engine to cool before refueling. Never smoke
while refueling.
I F C
NSTALL RONT OUNTER
The Front Counter-weight must be installed at all times
when operating the WD1260 with High Dump System
on uneven terrain or slopes. The Front Counter-weight
is not required if using the normal collector.
To install, put the Counter Weight on the front hitch.
Then secure with pin on each side of the Counter

Weight.

Figure 6-4
-
WEIGHT
Figure 6-5
17