Unpacking And Preparation; Removing Protective Foil; Fueling And Engine Service; Install Steering Wheel : F - Kioti WD1260 Operator's Manual

Read and understand operator's manual contents prior
to unpacking, assembling, or operating equipment.
For transportation reasons, the mower is often shipped
partially disassembled. Visually inspect the machine
for damage, loose nuts or bolts, and take note of the
safety signs and their messages. Contact your dealer
immediately if any hardware has not been included.
IMPORTANT: Remove tractor from pallet carefully to
avoid damage to the tractor or mower.
Package Contents:
 Tractor
 Steering wheel and
installation hardware
 Seat and installation
hardware: 2x bolt, 2x
spacer, 2x washer, 2x
nuts
Contents may vary according to model and customer
specifications.
R P
EMOVING ROTECTIVE
Your machine was shipped from the factory with a thin
plastic foil covering plastic components. Remove this
foil before operation if it has not already been
removed.
F E
UELING AND NGINE
The lawn mower may be shipped without oil and fuel
for safety. The crankcase must be filled with oil. See
maintenance section for the correct amount of oil to be
used.
I S W
NSTALL TEERING
1. Put the steering wheel on steering wheel shaft
2. Install nut and washer and tighten
3. Install steering wheel hub cap

6. UNPACKING AND PREPARATION

 Owner/Operator Manual
 2 Ignition keys
 Replacement fuses
 Replacement light bulb
 Grass container and
hardware
F
OIL
S
ERVICE
: F 6-1
HEEL IGURE
Figure 6-1
A S : F
DJUST EAT IGURE
The seat must be adjusted so that the operator can
reach all controls quickly and efficiently.
Seat position is adjusted by the slide handle (#6). Pull
handle away from seat and slide seat as needed.
Release handle.
Backrest tilt can be adjusted by the knob on the right
side of the seat (#7). Lumbar support can be adjusted
by the knob on the right back of the seat (#8).
H S
YDRAULIC YSTEM
1
Check the hydraulic oil level. Oil must be visible in the
oil mark (#1). RECOMMENDED HYDRAULIC OIL IS
15W40. Hydraulic oil level is approximately 10 liters.
I G C
NSTALL RASS OLLECTOR
For safety reasons the machine should never be
operated without one of the following installed:
Standard Collector, High Dump System or Dispersion
Hood. See following pages for instructions.
6-2
Figure 6-2
:
Figure 6-3
15