Product Identification - Bosch Rexroth VT-HNC100 3X Series Operating Instructions Manual

RE 30139-B/12.14 | VT-HNC100...X
VT-HNC100
Version Compact for 1 axis
Version for 1 hydraulic axis
Version for 2 hydraulic axes
Version for 3 hydraulic axes
Version for 4 hydraulic axes
Component series 30 to 39
(30 to 39: unchanged technical data and pinout)
The preparation of user-specific data sets forms the basis for the function of the
VT-HNC100...3X. These data sets are created on the PC and submitted to the
VT-HNC100...3X via the serial interface or optionally the TCP/IP. The connection
between user program and data sets is referred to as project.
The VT-HNC100...3X includes different controller functions which are described in
the data sheet.
Technical data, operating conditions and the limitation of use of the
VT-HNC100...3X axis control are available in the data sheet.
4.3

Product identification

VT-HNC100 3X
= Serial unit
= C
= 1
= 2
= 3
= 4
= 3X
Fig. 2: Order code
Bosch Rexroth AG
000 =
G02 =
G03 =
G04 =
00 =
E0 =
I =
(not in connection with Compact version)
S =
(only in connection with Compact version)
P =
C =
N =
(not in connection with Compact version)
E =
(not in connection with Compact version)
1) Only specify "E0" if the Ethernet service interface is desired
for "PROFIBUS DP"
Versions without bus connection are not available.
2)
13/48
Information on this product
Option
without synchronization
Synchronization 2-axis version
Synchronization 3-axis version
Synchronization 4-axis version
No fitting
TCP/IP
Position transducer
Incremental/SSI
SSI
Bus connection
PROFIBUS DP
CANopen
PROFINET RT
EtherNet/IP
1)
2)