Table of Contents
Advertisement
3. Motion Sensitivity
A. Set motion sensitivity.
B.
It can be set in between level 1 and 5 and lower the lever, higher the sensitivity so that it
enables to detect small motion. Therefore select the level appropriately.
4. Position Setting
A. Set position of motion detection of camera in advance.
B.
It start to detect at the set position after motion detection is set up
C. If the position is not set, it starts to detect at the current position.
5. Act of Motion Detection
A. It is set to act when motion is detected
i.
Alert Sound: It makes alert sound through speaker installed to Audio Out of camera
ii.
Alarm Out: It runs On/Off device that is connected to Alarm Out of camera.
iii.
Send Mail: It sends the time and condition of motion detection by e-mail that is set in
SMTP of network
1. Attached Record file: the file of image and sound recorded from the point that
motion was detected is attached to e-mail
6. Alert Time
A. It is the time for image recording and Alert Sound
B.
It can be chosen among 5, 10, 15 and 20 seconds
C. Infinity
i.
Alert Sound: It is in action until it is cancelled by user
ii.
Attached Record file: It records for up to 20 seconds. However, if any motion is detected
after 20 seconds, it does not record image or sound again.
7. Alarm Sound is generated through speaker of monitoring PC.
A. It is in action until checked by user
regardless
of
administration tool
Alarm rings through pc speaker
-
ick the icon to cancel.
- Cl
Alert
time
setup
Pan/Tilt Network Camera
of
- 49 -
User's Guide
Advertisement
Table of Contents
