Table of Contents
Advertisement
Before use
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Set-up procedure
In order to set up a network camera, please refer to the following procedure.
1
Make sure the type of network currently used and details to be inspected before set up (refer
the manual in pages 12~13)
2
Connect AC Adapter and power cord to power terminal of camera.
3
Connect LAN ports of both Camera and PC directly with Cross-Over cable or connect to the
Internet or LAN with Direct cable
(Refer to text in page 14)
4
The following methods should be considered when allocated IP address of camera is not
identified in dynamic IP environment.
-
Set up SMTP from administrator's page and receive by E-mail. (refer to text in page 43)
5
IP address can be set using two methods.
A. Establish camera IP using automatic IP setting program (Setup IP Software).
(Refer text in page 15-17)
B. Establish camera IP using IP address set by manufacturer temporarily
(Refer text in page 18~20)
6
Set up camera in an appropriate place and then connect power and LAN
(Refer text in pate 54~56)
7
If installed interior private IP network using router, set up port-forwarding that is high-quality
function of router. (refer text in page 21~22)
All products are set with same IP address when manufactured, IP address must be
changed after purchase. (192.168.1.1~3 must be not be used)
Pan/Tilt Network Camera
- 10 -
User's Guide
Advertisement
Table of Contents
