Safety Rules - powersoft DigiMod 500 User Manual

This device must be powered exclusively by earth connected mains sockets in electrical networks
compliant to the IEC 364 or similar rules.
Is absolutely necessary to verify this fundamental requirement of safety and, in case of doubt,
require an accurate check by a qualified personal.
Is absolutely necessary to ground this device using the proper earth connection on the metal frame
of the chassis, use M4 nut and proper Grover type washer to secure the earth terminal lug.
The constructor cannot be considered responsible for eventual damages caused to persons, things
or data for the missing of accurate earth link.
Provide the installed unit with bipolar switch to unconnect both mains connection with at least 3mm
of distance of the switch contacts.
Before powering this device verify that the module is supplied with the correct voltage rating.
Verify that your mains connection is capable to satisfy the power ratings of the device.
Do not spill water or other liquids into or on the unit.
Do not use this unit if the electrical power cord is frayed or broken.
Do not remove the cover. Removing the cover will expose you to potentially dangerous voltage.
No naked flame sources such like lighted candles should be placed on the module.
Contact the authorized center for ordinary and extraordinary maintenance.
Input mains and output power connection wirings must not to be accessible to the user.
The enclusure apparatus shall be designed so that the start and spread of fire is prevented as
much as possible , and shall not give rise to danger of fire to the surrounding of the apparatus.
This is achieved as follows:
- by using good engineering practice in design and production of the enclosure apparatus to
avoid potential ignition sources
- by using materials of low flammability for internal parts in the vicinity of potential ignition
sources
- by using fire enclosures to limit the spread of fire
ESD Precautions
This product is an Electrostatic Discharge Sensitive Device. It is recommended that all
workstations where the product is handled and assemblied should be provided with all
necessary devices and precautions to avoid damage from electrostatic discharges (e.g.
some form of ground conductive or dissipative flooring).
Powersoft s.r.l.
07/11/07
DigiMod 500/1000/1500/2000HV/1000NPS
- P. IVA n. 04644200489 – Via E.Conti, 5 Scandicci - Tel.: (+39) 055 7350230- Fax: 055 7356235
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN

Safety rules

!
3