Table of Contents
Advertisement
COIN MECHANISM - VENDED MODEL ONLY
13.11 MAINTENANCE
The cleaning frequency depends on the environment and number of transactions of the coin acceptor. It is recommended to
clean the coin acceptor every six months for normal environment or/and infrequent usage, and every three months for harsh
environment or/and frequent usage.
1. Disconnect the power supply before removing and cleaning the acceptor
2. Remove the coin acceptor from its front panel
3. Open the side cover. Do not overbend the spring by opening it wider than 90 degrees
4. Clean the coin path with a soft brush and wipe it with an alcohol-dampened cloth
5. Do not clean the coin path with oil-based cleaning agent as the residue will prevent or block the IR signal
6. Clean IR Transceiver holes with soft brush or air spray duster
7. Make sure the light reflector at the bottom is clean
8. Reinstall the coin acceptor back to the front panel
9. Reconnect the wire to ensure the coin acceptor is working properly.
46
Part. 14000001 Rev. 04//2021
®/™ ©2021 Unity Laundry Systems. All rights reserved.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the UTS40 and is the answer not in the manual?
Questions and answers
door pin error no 6
Door Pin Error No. 6 for UNITY LAUNDRY SYSTEMS UTS40 means there is an issue with the door pin or the lock release cord. It is recommended to check these components to resolve the error.
This answer is automatically generated