Storage Recommendations; Troubleshooting - Mark 7 Evolution User Manual

Hide thumbs Also See for Evolution:

Table of Contents

When adjusting the index pawl its best practice to remove the Tool Head and shell plate nut so the index

pawl can be seen in the shell plate indexing hole. With the machine at the top of the stoke the index pawl

should be adjusted so the leading edge of the pawl is in contact with the inside wall of the shell plate

indexing hole. Once this is set remove the shell plate and confirm that the index pawl is between .060 -

.100" above the top plate surface.

Storage Recommendations

The following is the proper procedure for storage after a session of use:

1. Ensure that the shell plate is clear of any brass and clean any powder or brass shavings

2. Apply a light weight coat of oil to all black oxide fasteners and metal surfaces.

3. Check the need for lubrication after every session and apply it as necessary at the key

lubrication points outlined in the user manual. Insufficient lubrication creates a potentially

dangerous situation and may lead to unreliable results

4. Turn off the power to the case feeder and the bullet feeder

5. Keep light weight oil on all metal surfaces.

Refer to the knowledge base section on our website under SUPPORT for troubleshooting articles

relating to setup and operation.

http://www.markvii-loading.com/

Mark 7 ® Digital Community at www.markvii-loading.com

Please contact us for technical support

https://www.markvii-loading.com/supports/customer-service-support.html

Phone: 1-888-462-7577

Hours: 8:30am-5:00pm, ET, M–F

Table of Contents

Do you have a question about the Evolution and is the answer not in the manual?