Event Page - Kurzweil PC4 SE Musician's Manual

Song Mode

Event Page

Keeping the Mixer Settings
Press the ENTER button to view the Keep dialog, which allows you to capture the current
values for each track's program, panning, and volume as the initial values. After using the
Keep dialog, remember to save the song if you want these changes to be permanent.
If you don't use the Keep dialog, tracks will not have initial program, panning, and volume
values unless they are manually set for each track. See the Vol, Pan, Prog section above for
details on manually setting initial values for each track.
Note: Don't use the ENTER button if you would like certain tracks to not be stored with
initial values. In this case, only set initial values for each desired parameter as described in
"Setting Initial Volume Per
Event Page
The Event page allows you to view and modify any MIDI event on each track. Every type of
recorded MIDI event is visible from this page. You can also access the tempo track.
The top line of the page displays the current song location, and the currently selected track
and corresponding channel. Use the BANK -/+ buttons to select a track. Each track displays
its initial program, volume, and pan at the top of its event list.
To scroll through the events, make sure the location (Bar and Beat, in the left column) is
highlighted. Use the ALPHA WHEEL or NAVIGATION Up/Down buttons to move
through the list. As you scroll through the events, each event is executed by the sequencer. In
the case of Note events, you will hear the note played, although the duration will be short.
If you have scrolled through a Sustain (CTRL 64) message with a value of 127 then you will
hear the note sustain as if the sustain pedal was depressed. The note will continue to sustain
until you scroll through a Sustain message with a value of 0.
7-20
Track".