Kurzweil PC4 SE Musician's Manual page 114

Multi Edit Mode
Controls Page
MIDI Dest
Use the MIDI Dest field to select a parameter to control.
Destinations 0-127 are MIDI continuous controller messages (CC numbers), which can be
used to control PC4 SE Program parameters, or external MIDI gear.
CC numbers that are assigned to Program parameters will show the parameter name next to
the CC number. These CC numbers will control the Program in the current Zone.
Destinations 128 and greater can be used to control PC4 SE Program and Multi functions.
For details see
Note: When Controller is set to ArpOn/Off or ArpLatch, the MIDI Dest parameter can
only be set to Arp On/Off or Latch destinations.
On
The On field determines the "On Value", the MIDI value sent when a switch controller is set
to On. You can set this parameter to any number between 0 and 127, or to None.
Off
The Off field determines the "Off Value", the MIDI value sent when a switch controller is set
to Off. You can set this parameter to any number between 0 and 127, or to None.
Entry
The Entry parameter determines the state of a switch controller when the current Multi is
loaded. You can set this parameter to None, On, or Off. This parameter affects the selected
switch controller for all Zones.
If Entry is set to None, then when you load the current Multi, the switch controller state will
not change.
Exit
The Exit parameter determines the state of a switch controller when the current Multi is
exited by selecting another Multi or Program. You can set this parameter to None, On, or
Off. This parameter affects the selected switch controller for all Zones.
Exit should typically be set to a value of "None", which sends no message. Setting Exit to On
or Off can be useful for advanced MIDI configurations and when controlling external MIDI
instruments or software.
5-26
"Controller Destination List" on page 5-31.