Master Fx Page - Kurzweil PC4 SE Musician's Manual

Master FX Page

The Master FX page contains master EQ and compressor settings. When the master EQ or
compressor is enabled, all audio signals from the PC4 SE are processed by these effects.
When the EQ is set to On, use the EQ Low, Mid and Hi Gain parameters to boost or cut
each frequency range. Use the Mid Freq parameter to set the center frequency of the Mid
range.
When the Compressor is set to On, use the Comp Amount parameter to set the compression
amount between 1 (least compressed) and 11 (most compressed).
EQ Button
When viewing the Global mode Master FX page, turn on the front panel EQ button to
control the parameters with the CONTROL section knobs and buttons as described below.
Use the Switch 1 button to enable/disable the Master EQ, and use the first 4 Knobs in the
CONTROL section to control the 4 on screen Master EQ parameters.
Use Knob 5 in the CONTROL section to control the Master Compressor. When the knob is
all the way down, the compressor is disabled. Turn the knob up to enable the compressor and
increase the compression amount.
In Program and Multi Mode, you can also turn on the EQ button to view and control the
Master FX parameters with the CONTROL section knobs and buttons as described above.
Turn off the EQ button to return the CONTROL section knobs and buttons to their
Program or Multi assignments.
Note: When you exit Global Mode, the current Master FX settings will be saved as default
settings to be applied when the PC4 SE is powered on. To save Master FX settings set in
Program or Multi Mode as default settings, you must enter and exit Global Mode.
Global Mode
Master FX Page
6-15