Kurzweil PC4 SE Musician's Manual page 15

Getting Started
The Front Panel
EQ Button
On the main Program and Multi Mode pages, turn on the EQ button to view and control
the Master FX parameters, which can apply EQ and compression to all audio produced by
the PC4 SE.
When viewing the Master FX parameters, use the Switch 1 button to enable/disable the
Master EQ, and use the first 4 Knobs in the CONTROL section to control the 4 on screen
Master EQ parameters.
When viewing the Master FX parameters, use Knob 5 in the CONTROL section to control
the Master Compressor. When the knob is all the way down, the compressor is disabled.
Turn the knob up to enable the compressor and increase the compression amount.
Note: To set your Master FX settings as default settings to be applied when the PC4 SE is
powered on, you must enter and exit Global Mode, or select the desired settings on the
Global Mode Master FX page, then exit Global Mode to save the settings as defaults.
When viewing the Global mode Master FX page, turn on the EQ button to control the
parameters with the CONTROL section knobs and buttons as described above.
Turn off the EQ button to return the CONTROL section knobs and buttons to their
Program or Multi assignments.
ARPEGGIATOR Section
Use the ARP and LATCH buttons to control the PC4 SE's Arpeggiator.
Use the CC SEQ button to turn the CC Sequencer On or Off.
Use the TAP TEMPO button to set the tempo of the Arpeggiator and CC Sequencer, the
rate of tempo synced FX (such as Delay), or the tempo of the current Multi or Song. To set
the tempo, press the TAP TEMPO button a few times at the desired rate. You can also set
the tempo by pressing the TAP TEMPO button, then adjusting the tempo with the ALPHA
WHEEL, or by using the KEYPAD buttons to type a numeric value followed by pressing
ENTER.
1-8