Kurzweil PC4 SE Musician's Manual page 72

When the Sync parameter is set to All Keys Up, the sequence begins playing as soon as the
program is selected, and it restarts whenever it reaches the end of the sequence, or whenever
all keys have been released.
When the Sync parameter is set to Arp, the sequence begins playing only when the program's
arpeggiator is playing, and it restarts whenever it reaches the end of the sequence.
When the Sync parameter is set to Arp with Reset, the sequence begins playing only when
the program's arpeggiator is playing, and it restarts whenever it reaches the end of the
sequence, or whenever the program's arpeggiator restarts its sequence.
The AnyOther CCSeq setting only applies to Multi Mode. When the Sync parameter is
set to AnyOther CCSeq, the sequence begins playing as soon as the Multi is selected, and
it restarts whenever it reaches the end of the sequence, or whenever a CC Sequence for a
program in another Zone begins or restarts.
Note Value
The Note Value parameter sets the number of steps that will be played per beat. The tempo is
based on quarter notes. Therefore, if you set Note Value to 1/4, you will get one step per beat
of the clock. At 1/16, you will get 4 steps per beat, and so forth.
MIDI Dest
The MIDI Dest parameter sets the MIDI destination for the CC messages generated by the
CC Sequencer. You can send CC messages to a PC4 SE Program, to the MIDI Out ports, to
the USB port, or to any combination of these destinations.
By default, CC messages are sent to all possible destinations. When using the PC4 SE to
control or layer with external MIDI instruments, you may wish to send CC messages only to
certain destinations.
In Program Mode, when the MIDI Dest parameter is set to Zone, the CC messages will be
sent to the PC4 SE Program and to the MIDI and USB ports.
In Multi Mode, when the MIDI Dest parameter is set to Zone, the CC messages will be sent
to the destination set by the Zone's Main page Destination parameter.
Seq State
The CC Sequencer can play 4 simultaneous sequences which can each control a different
parameter or CC number. Use the Seq State parameter to turn the selected sequence On or
Off.
Program Edit Mode
MIDI CC Step Sequencer Page
3-29