Kurzweil PC4 SE Musician's Manual page 115

Continuous Controllers
This section describes parameters for the following continuous controllers:
• Modulation Wheel
• Pitch Wheel up and down
• CONTROL Knobs 1-5
• CONTROL Sliders 1-5
• CC pedal
Controller
Use the Controller field to select a controller for the currently selected Zone.
When the Controller field is selected, you can select a controller by using the ALPHA
WHEEL, or by holding the ENTER button and moving a controller.
If a pedal is selected which has a pedal override enabled in Global mode, a message "Global
Pedal Override is enabled" will display when that pedal is viewed to remind you that the
Global mode pedal override settings are being used instead of the Multi mode pedal settings.
Mode
Continuous Controllers can be set to the following modes: Off, or MIDI CC.
When Mode is set to Off, the controller is disabled for this zone.
When Mode is set to MIDI CC, the controller can send MIDI control messages.
MIDI Dest
Use the MIDI Dest field to select a parameter to control.
Destinations 0-127 are MIDI continuous controller messages (CC numbers), which can be
used to control PC4 SE Program parameters, or external MIDI gear.
CC numbers that are assigned to Program parameters will show the parameter name next to
the CC number. These CC numbers will control the Program in the current Zone.
Destinations 128 and greater can be used to control PC4 SE Program and Multi functions.
For details see "Controller Destination List" on page
Multi Edit Mode
5-31.
Controls Page
5-27