Table of Contents
Advertisement
M3
8. RS232 COMMUNICATION
The M3 can communicate with an ASCII protocol allowing to master and configure all the
functions.
For connecting the M3 to a PC or a PLC, you must use a cable Metro ref 45160, sold
separately.
8.1.
Commands
8.1.1. Generalities
All the commands must be ended by a « CR » character. (ASCII code 13/ $0D).
The commands can be sent grouped by separating with a «;» (max 500 characters).
The display is refreshed only once after reception of the « CR » character.
Page 63
Advertisement
Table of Contents
Need help?
Do you have a question about the M3 and is the answer not in the manual?