Raider RD-CM06 User Manual page 12

12 www.raider.bg
accidents.
1.3.4. Remove any adjusting key or wrench before turning the power tool on. A
wrench or a key left attached to a rotating part of the power tool may result in personal
injury.
1.3.5. Do not overreach. Keep proper footing and balance at all times. This enables
better control of the power tool in unexpected situations.
1.3.6. Dress properly. Do not wear loose clothing or jewellery. Keep your hair,
clothing and gloves away from moving parts. Loose clothes, jewellery or long hair can
be caught in moving parts.
1.3.7. If devices are provided for the connection of dust extraction and collection
facilities, ensure these are connected and properly used. Use of dust collection can
reduce dust-related hazards.
1.4. Power tool use and care.
1.4.1. Do not force the power tool. Use the correct power tool for your application.
The correct power tool will do the job better and safer at the rate for which it was
designed.
1.4.2. Do not use the power tool if the switch does not turn it on and off. Any power
tool that cannot be controlled with the switch is dangerous and must be repaired.
1.4.3. Disconnect the plug from the power source and/or the battery pack from the
power tool before making any adjustments, changing accessories, or storing power
tools. Such preventive safety measures reduce the risk of starting the power tool
accidentally.
1.4.4. Store idle power tools out of the reach of children and do not allow persons
unfamiliar with the power tool or these instructions to operate the power tool. Power
tools are dangerous in the hands of untrained users.
1.4.5. Maintain power tools. Check for misalignment or binding of moving parts,
breakage of parts and any other condition that may affect the power tool's operation.
If damaged, have the power tool repaired before use. Many accidents are caused by
poorly maintained power tools.
1.4.6. Keep cutting tools sharp and clean. Properly maintained cutting tools with
sharp cutting edges are less likely to bind and are easier to control.
1.4.7. Use the power tool, accessories and tool bits etc. in accordance with these
instructions, taking into account the working conditions and the work to be performed.
Use of the power tool for operations different from those intended could result in a
hazardous situation.
1.5. Service.
1.5.1. Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
1.6. Safety Warnings for Cut-off Grinder.
1.6.1. Never stand on the power tool. Serious injuries could occur when the power
tool tips over or when accidentally coming into contact with the cutting disc.
1.6.2. Make sure that the guard operates properly and that it can move freely. Never
lock the guard in place when opened.
1.6.3. Use the power tool only for dry cutting. Water penetrating into a power tool
increases the risk of an electric shock.
1.6.4. Keep the mains cable away from rotating application tools. The mains cable
can be cut through or get caught.
1.6.5. Keep the handle dry, clean and free from oil and grease.
1.6.6. Keep hands away from the cutting area while the machine is running. Danger
of injury when coming into contact with the cutting disc.
1.6.7. Do not stand in a line with the cutting disc in front of the machine. Always
stand aside of the cutting disc. This measure provides for better protection of your
body against possible splinters in case of cutting disc breakage.