Adding Snmp Traps; Configuring Access Control Rules - Cisco RV120W Administration Manual

Administering Your Cisco RV120W
Configuring Network Management
STEP 4
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 1
STEP 2
STEP 3
STEP 4
Cisco RV120W Administration Guide
If you chose AuthPriv, choose the type of privacy algorithm (DES or AES) and enter
the privacy password.
Click Save.

Adding SNMP Traps

The Traps List Table lists IP addresses of SNMP agents to which the router will
send trap messages (notifications) and allows several operations on the SNMP
agents.
To add a new trap:
In the Trap Table, click Add.
Enter the IP Address of the SNMP manager or trap agent.
Enter the SNMP trap port of the IP address to which the trap messages will be
sent.
Choose the SNMP Version: v1, v2c, or v3.
Enter the community string to which the agent belongs. Most agents are
configured to listen for traps in the Public community.
Click Save.

Configuring Access Control Rules

The SNMP v1/v2c Access Control Table is a table of access rules that enables
read-only or read-write access for select IP addresses in a defined SNMP agent's
community.
To configure access control rules:
In the SNMP v1/v2c Access Control Table, click Add.
Enter the IP Address of the specific SNMP manager or trap agent on which to
create an access rule.
Enter the subnet mask used to determine the list of allowed SNMP managers.
Enter the community string to which the agent belongs. Most agents are
configured to listen for traps in the Public community.
7
122