Configuring Snmp Traps; Snmp System Information - Cisco Small Business RV220W Administration Manual

Administering Your Cisco RV220W
Network Management (SNMP)
STEP 1
STEP 2
STEP 1
Cisco RV220W Administration Guide

Configuring SNMP Traps

Use the Add / Edit Trap Configuration page to identify SNMP agents to which the
router will send trap messages (notifications).
To open this page: From the Administration > Network Management > SNMP
page, in the Traps Table, click Add or select a trap and then click Edit.
Enter these settings:
• IP Address—Enter the IP address of the SNMP manager or trap agent.
• Port—Enter the SNMP trap port of the IP address to which the trap
messages will be sent.
• SNMP Version—Choose the SNMP Version: v1, v2c, or v3.
• Community—Enter the community string to which the agent belongs. Most
agents are configured to listen for traps in the Public community.
Click Save to save your settings, or click Cancel to reload the page with the
current settings. Click Back to return to the Administration > Network
Management > SNMP page.

SNMP System Information

Use the Administration > Network Management > SNMP System Information
page to specify reference information for your SNMP Management Information
Base (MIB).
To open this page: In the navigation tree, choose Administration > Network
Management > SNMP System Information.
Enter the following MIB (Management Information Base) settings:
• SysContact—Enter the name of the contact person for this router. Examples:
admin, John Doe.
• SysLocation—Enter the physical location of this router. Example: Rack #2,
4th Floor.
9
171