Creating Cisco Quickvpn Client Users; Configuring A Basic Vpn - Cisco RV120W Administration Manual

Configuring Virtual Private Networks (VPNs) and Security

Configuring a Basic VPN

STEP 1
STEP 2
Configuring a Basic VPN
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco RV120W Administration Guide

Creating Cisco QuickVPN Client Users

To use the Cisco QuickVPN, you must do the following:
Enable remote management. See
Create QuickVPN users. See
account is created, the credentials can be used by the QuickVPN client.
For more information on installing and using Cisco QuickVPN, see
"Using Cisco QuickVPN for Windows 7, 2000, XP, or Vista."
Use the basic VPN setup function to create a VPN with default values as proposed
by the VPN Consortium (VPNC) and a Pre-shared Key (PSK). You can change
these values later if you need to further configure any VPN parameters.
To configure a basic VPN:
Choose VPN > IPsec > Basic VPN Setup.
Choose to which peers the VPN tunnel will connect:
• Gateway—Connects the Cisco RV120W to a gateway using a secure
tunnel.
• VPN Client—Connects the Cisco RV120W to remote clients. The remote
clients must run VPN client software.
Enter a name for the connection. The connection name is used for management.
Enter a pre-shared key. The VPN client or gateway will need to enter this key to
establish the VPN connection.
Choose the type of address for the remote gateway, or the gateway to which the
Cisco RV120W will connect:
• IP Address—Enter the IP address of the gateway in the field below.
• FQDN (Fully-Qualified Domain Name)—Enter the domain name in the field
below (for example, http://www.cisco.com).
Configuring Remote Management, page
Configuring VPN Users, page
5
119.
105. After a user
Appendix A,
93