Configuring The Ipv4 Wan (Internet); Configuring Automatic Configuration (Dhcp) - Cisco RV120W Administration Manual

Configuring Networking
Configuring the WAN (Internet) Settings
STEP 1
STEP 2
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco RV120W Administration Guide

Configuring the IPv4 WAN (Internet)

Choose Networking > WAN (Internet) > IPV4 WAN (Internet).
Choose the type of Internet connection you have. The type of connection you have
determines the rest of the information you need to enter. See the sections below
for more information:
• Configuring Automatic Configuration (DHCP), page 20
• Configuring Static IP, page 21
• Configuring PPPoE, page 21
• Configuring PPTP, page 22
• Configuring L2TP, page 23

Configuring Automatic Configuration (DHCP)

If your Internet Service Provider (ISP) uses the Dynamic Host Configuration
Protocol (DHCP) to assign you an IP address, you receive a dynamic IP address
from your ISP.
To configure DHCP WAN settings:
Choose Networking > WAN (Internet) > IPv4 WAN (Internet).
From the Internet Connection Type drop-down menu, choose
Automatic Configuration - DHCP.
Enter MTU information. (See
Enter MAC Address information. (See
Click Save.
Configuring MTU Settings, page
Configuring the MAC Address, page
2
24.)
24.)
20