Configuring Pptp - Cisco RV120W Administration Manual

Configuring Networking
Configuring the WAN (Internet) Settings
STEP 5
STEP 6
STEP 1
STEP 2
STEP 3
STEP 4
Cisco RV120W Administration Guide
Enter MAC Address information. (See
Click Save.

Configuring PPTP

If you have a Point-to-Point Tunneling Protocol (PPTP) connection to the Internet:
Choose Networking > WAN (Internet) > IPv4 WAN (Internet).
From the Internet Connection Type drop-down menu, choose PPTP.
Enter this information:
User Name
Password
MPPE Encryption
Connection Type
Idle Time
My IP Address
Server IP Address
Enter MTU information. (See
Configuring the MAC Address, page
Enter your username assigned to you by the ISP.
Enter your password assigned to you by the ISP.
If your ISP supports Microsoft Point-to-Point
Encryption (MPPE), check to enable MPPE
encryption.
Choose the connection type:
• Keep connected—The Internet connection is
always on.
• Idle Time—The Internet connection is on
only when traffic is present. If the connection
is idle—that is, no traffic is occurring—the
connection is closed. You might want to
choose this option if your ISP charges based
on connection time.
If you choose Idle Time as the connection type,
enter the number of minutes after which the
connection terminates. The valid range is 5–999.
Enter the IP address assigned to you by your ISP.
Enter the IP address of the PPTP server.
Configuring MTU Settings, page
2
24.)
24.)
22