Configuring Vpn Users; Configuring A Pptp Server - Cisco RV120W Administration Manual

Configuring Virtual Private Networks (VPNs) and Security
Configuring Advanced VPN Parameters
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco RV120W Administration Guide
The Active IPsec SAs table displays a list of active IPsec SAs. Table fields are as
follows:
Field
Policy Name
Endpoint
Packets
Kbytes
State
Action

Configuring VPN Users

To view a list of VPN users, choose VPN > IPsec > VPN Users. The VPN gateway
authenticates users in this list when XAUTH is used in an IKE policy. QuickVPN
clients can access only default LAN hosts.

Configuring a PPTP Server

If you are using a Point-to-Point Tunneling Protocol VPN server:
Choose VPN > IPsec > VPN Users.
Under PPTP Server, check the Enable box.
Enter the IP address of the PPTP server.
In the Starting IP Address field, enter the starting IP address of the range of IPs to
assign to connecting users.
In the Ending IP Address field, enter the ending IP address of the range of IPs to
assign to connecting users.
Description
IKE or VPN policy associated with this SA.
IP address of the remote VPN gateway or client.
Number of IP packets transmitted over this SA.
Kilobytes of data transmitted over this SA.
Status of the SA for IKE policies: Not Connected or
IPsec SA Established.
Choose Connect to establish a connection, or Drop
to terminate an established connection.
5
105