Configuring Mtu Settings; Configuring The Mac Address - Cisco RV120W Administration Manual

Configuring Networking
Configuring the WAN (Internet) Settings
STEP 5
STEP 6
STEP 1
STEP 2
STEP 3
Cisco RV120W Administration Guide
Enter MAC Address information. (See
Click Save.

Configuring MTU Settings

The Maximum Transmission Unit (MTU) is the size of the largest packet that can be
sent over the network. The default MTU value for Ethernet networks is usually
1500 bytes and for PPPoE connections, it is 1492 bytes.
To configure the MTU settings:
Choose Networking > Choose Networking > WAN (Internet) > IPv4 WAN
(Internet).
Choose the MTU type:
• Default—Unless a change is required by your ISP, we recommend that
you choose Default in the MTU Type field. The default MTU size is 1500
bytes.
• Custom—If your ISP requires a custom MTU setting, choose Custom and
enter the MTU size in the MTU Size field.
Click Save.

Configuring the MAC Address

The Cisco RV120W has a unique 48-bit local Ethernet hardware address. In most
cases, the default MAC address is used to identify your Cisco RV120W to your ISP.
However, you can change this setting if required by your ISP.
Configuring the MAC Address, page
2
24.)
24