Wacker Neuson BS 50-4 Repair Manual page 66

Ramming System
4.1.20 Fasten the guide cylinder to the crankcase. Apply Loctite 243 and
4.1.21 Lay the rammer flat on the ground and align the protective pipe with
4.1.22 Position the clamps so that the clamp screws (k) are in line with the
4.1.23 Tighten the clamps and torque them to 13.5 Nm (10 ft.lbs.).
4.1.24 Fill the ramming system with clean oil as described in section
4.1.25 Run the rammer for several minutes and check it for oil leaks around
wc_tx000286gb.fm
torque the screws to 43 Nm (32 ft.lbs.).
the upper machinery.
sightglass (m).
Ramming System Lubrication.
the guide cylinder and the bellows.
66
Rammer Repair