Fluke LinkIQ User Manual page 17

LinkIQ
Users Manual
3. Connect one end of the CAT6A copper patch cable or other approved cable into the RJ45
jack on the Product. See
02/15/2021 09:56 AM
4. Connect the other end of the patch cable into an RJ45 jack or into an adapter that is
connected to the near end of the cable under test. Then, connect the Remote ID into an RJ45
jack or adapter that is connected to the far end of the cable under test.
Or,
Connect the Remote ID into an RJ45 jack or into an adapter that is connected to the near end
of the cable under test. Then, connect the other end of the patch cable into an RJ45 jack or
into an adapter that is connected to the far end of the cable under test.
5. Tap AUTO TEST to do a test.
The results show on the display. See
6. To save the results. See
14
1.800.561.8187
Figure 2.
Figure 2. Cable Test Set Up
Table 8.
Save a Test Result.
www. .com
02/15/2021 09:56 AM
information@itm.com