Fluke LinkIQ User Manual page 12

Option Menu
Allow
Crossover
Pinout
Cable Settings
Test Limit
NVP
1.800.561.8187
Table 6. Settings Menu (cont.)
Option
The wire map of either a straight through cable or a
On
crossover cable is used to determine if a test passes.
The wire map of a straight through cable is used to
Off determine if a test passes. A wire map of a crossover
cable fails. Default setting.
Select to set the pinout configuration to use to do a test.
<options>
T568A is the default setting.
Verify if a cable with continuity on at least the 1,2 and 3,6
10BASE-T pairs can support 10BASE-T (10) data rate throughput.
Default setting.
Verify if a cable with continuity on at least the 1,2 and 3,6
100BASE-TX pairs can support 100BASE-TX (100) data rate
throughput.
Verify if a 4-pair cable with continuity on all 4 pairs can
1000BASE-T
support 1000BASE-T (1G) data rate throughput.
Verify if a 4-pair cable with continuity on all 4 pairs can
2.5GBASE-T
support 2.5GBASE-T (2.5G) data rate throughput.
Verify if a 4-pair cable with continuity on all 4 pairs can
5GBASE-T
support 5GBASE-T (5G) data rate throughput.
Verify if a 4-pair cable with continuity on all 4 pairs can
10GBASE-T
support 10GBASE-T (10G) data rate throughput.
Set the Nominal Velocity of Propagation (NVP) value
50-99
based on the cable. The default NVP value is 68.
www.
Description
information@itm.com
.com
Cable+Network Tester
Main Menu
9