Advertisement
E T C I n s t a l l a t i o n G u i d e
Surface Mount Us ing Tape or Velcro
You can use double-sided tape or Velcro to attach the station. Attaching
material is not included.
Step 1: Attach two 1.5 inch (4cm) strips of tape or Velcro to the back of the
station, ensuring they do not extend beyond the edge.
Step 2: Do one of the following:
• If using double-sided tape, remove the protective film to reveal the
sticky surface.
• If using Velcro, attach the opposite Velcro material to its mating
strips and then remove the protective film to reveal the adhesive.
Step 3: Press the station into place.
Step 4: Do one of the following:
• If using power from a computer, connect the mini B end of the USB
cable to the station and the type A end of the cable to a USB port
of a computer.
• If using the wall power supply, connect the mini-B end to the
station and the other end to a 100-240 VAC power outlet.
Linkin g to a Contr oller
After the SimpleTap Cubicle Station has been installed, it must be linked to the
correct controller. Reference the Unison Aero 902 MHz User Programming
Guide. ETC documentation is available for free download at
www.etcconnect.com.
Contains FCC ID: SZV-TCM300U
The enclosed device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(I.) this device may not cause harmful interference and
(ii.) this device must accept any interference received, including
interference that may cause undesired operation.
Contains IC: 5713A-TCM300U
Pa ge 3 o f 3
Control Series
Si mpl eT ap Cub ic le Sta t io n
Advertisement
