Table of Contents
Advertisement
Mounting
H ANG I NG BRACKET & F IXT URE F LO O R STANDS
Mount the hanging bracket on the fixture as illustrated on the right. The
tension knob is unique in that it is self ratcheting, providing you tool-free
tensioning of the bracket. Pull knob handle towards you and turn either to
apply tension or to release tension. Also included are two fixture floor
stands and a convenient hex wrench tool for fastening them. The wrench
also opens the fixture's front and back covers.
O RI ENT AT I O N
This fixture may be mounted in any position provided there is adequate room for ventilation. It is also
possible to stand this fixture using the removable floor stands.
RI G G I NG
It is important never to obstruct the fan or vents pathway. Mount the fixture
using, a suitable "C" or "O" type clamp. Adjust the angle of the fixture by
loosening both knobs and tilting the fixture. After finding the desired
position, retighten both knobs.
When selecting installation location, take into consideration lamp
replacement access and routine maintenance.
Safety cables should always be used.
Never mount in places where the fixture will be exposed to rain,
high humidity, extreme temperature changes or restricted ventilation.
Lamp Alignment
L AMP AL I G NMENT HO W-T O
Often, after a new installation of a lamp, you will find that there is an uneven field of light or what is referred
to as a hot spot. This is due to the most intense point of the lamp source not being positioned optimally
within the reflector.
There are three lamp alignment screws provided
at the base of the fixture. Turning these screws
allow you to optimize the projection quality of the
spot as well as the overall intensity of the beam.
1)
Project a white spot against any flat
surface. Preferably the surface should be
white or pastel in color.
2)
Turning the lamp alignment screws, try to
position the hot spot in the center of the
beam as best as possible. This could
require many attempts on your part. It is advisable to even out the screws prior to
lamp alignment as described in the illustration.
3)
Once the hot spot is in the center of the spot, do your best to turn all screws equally as
to affect movement up or down within the reflector.
4)
As you move in and out of optimum lamp focus, you will see the hot spot either get wider
or narrower. The goal is to either totally diminish the hot spot by having it widen and
spread across the entire spot or moving the hot spot so that it covers as much of the beam
spot area as possible.
ILS-606 & ILS-625 User Manual
Lamp alignment screws
PIN 1 - CO MM
PIN 2 - DM X
-
PIN 3 - DM X
+
OU TPU T
IN P UT
A djus t la m p p os itio n by tur nin g s c r e ws A ,B a nd C .
D is c onne c t pow e r a nd wa it 5 m in. be fo re ope ning .
Even out this plate by turning the
ON LY FOR
S EN S ITIV ITY
M IC
R EM OTE C ON TR OL
lamp alignment screws, prior to
CON F I GU RAT I ON
CH 1 =PA N
CH 2 =T I LT R OT AT I ON
lamp optimization. This will
CH 3 =S HU T T ER / SH AK IN G
CH 4 =G OBO
CH 5 =C OL OR
CH 6 =G OBO R OTAT I ON
provide you a good starting point.
CH 7 =D I MM ER
7
Setup
Hanging Bracket
Note!
Clamp is sold separately.
PO WER
FU SE
Mo d el:
Se rial N o:
Po w er:
F use :
Bu lb:
2005-03-09/22:45
Advertisement
Table of Contents
