Fuse Replacement - Chauvet COLORado 6 User Manual

Len s Assem mbly Insta
The e COLORado™6 c
opt tional lens assembl
inst tructions for proper
6 6 screws around
1. There are 6 sc
2. After removing
LED's. Remov
3. Place the new
4. Replace the o
Warni ing! When replacing Wh
dis sconnected fr
Ple ease also mak
the e new lens ass
the e IP66 protect
Fus e Replac cement
Th ere is no externa
ope eration. Howeve
fus se. This fuse can
don ne properly, then
CO OLORado™6 Us ser Manual
allation/Re eplaceme
comes with 15° lens s assembly pre-inst
lies available as ac ccessories which w
r replacement/insta allation.
d each LED modu ule
crews located ar round each modu
g the front cover , there are 5 scre
ve these and tak e out the lens as
w lens assembly o over the Led's, b
i. Note: : the center module
ii. Note: : there are multiple
over the LED's. Failure
dama age to the physical
this.
outer plastic cove er, being careful t
g the lens asse embly, please
rom the fixture e beforehand.
ke sure that th he covers are
sembly is inst talled, as failu
tion, and poss sibly the warra
al fuse in this fixt ure. This fixture
r, if a power surg ge occurs above
be accessed by y removing the ba
n the IP66 rating may be comprom
The fus se is located insi
compa artment.
Warnin ng: Removal of th
compa artment may com
the IP6 66 rating.
ent
talled from the fact ory. However, ther
ill alter the beam a ngle. Please follow
5 s screws that hold the lens
as sembly in place
ule.Remove all 1 8 screws for the
ews that hold eac ch lens assembly
ssembly.
being careful to g get the correct ali
e is different from th he outer 2 modules
possible position in in which to place th
to install it properly y can lead to loss o
LED's. Please see e the diagram locate
to make a watert tight seal.
make sure th at the power i
sealed tightly y when replaci
ure to accomp plish this will c
anty.
can handle 100- 240 volts of pow
the recommend ed voltage, there
ack cover where the display is lo
mised.
ide this
his
mpromise
12
re are 3 other
w the below
LENS
ASSEMB BLY
front cover.
y in place over th he
ignment.
s.
he lens assembly
of light output and/o or
ed above to preven nt
is
ing them after r
compromise
wer for normal
e is an internal
cated. If this is n ot
1/ 15/2008 11:12 AM