Colorcon™ Setup - Chauvet COLORado 6 User Manual

COLORcon™ setup
1.
2.
Single Row
Application
SET UP DOWN
Repeat Row Block Application
ID Address: 01
ID Address: 01
ID Address: 01 ID Address: 02
The figure above shows 9 fixtures connected in
series. Three rows comprised of 3 fixtures are
addressed identically. Each fixture has {ID ON} in
the fixture's settings. You must set the {Range}
settings in the controller to [003] before accessing
{Effect} programs.
COLORado™6 User Manual
FIXTURE CONTROL PANEL SETUP
Activate ID addressing in each fixture by setting panel function {ID ON/OFF} to ON.
{MENU} {Settings) {ID ON/OFF}
Set ID addresses in each fixture by setting panel function {ID address} to incremental
values. (I.e. 1,2,3,4,5,6,etc...)
{MENU} {Settings} {ID address}
It is not necessary to set the DMX address.
CONTROLLER SETUP
When using the {Effect program} function, it is necessary to set the {Settings}
{Range} setting, which is the quantity of fixtures in series.
{MENU} {Settings} {Range}
ID Address: 01
ID Address: 02
The figure above shows 6 fixtures connected in series with corresponding addresses.
Each fixture has {ID ON} in the fixture's settings. You must set the {Range} settings
in the controller to [006] before accessing {Effect} programs.
EXIT
ID Address: 02 ID Address: 03
ID Address: 02 ID Address: 03
ID Address: 03
SET UP
[ON]
[01 ~ 66]
[ (No. of fixtures) ]
ID Address: 03 ID Address: 04
Block Application
ID Address: 01
ID Address: 04
ID Address: 07
The figure above shows 9 fixtures
connected in series with corresponding
addresses. Each fixture has {ID ON} in
the fixture's settings. You must set the
{Range} settings in the controller to
[009] before accessing {Effect}
DOWN EXIT
programs.
17
ID Address: 05
ID Address: 06
ID Address: 02 ID Address: 03
ID Address: 05 ID Address: 06
ID Address: 08 ID Address: 09
SET UP DOWN
1/15/2008 11:12 AM
EXIT