Mounting; Orientation; Rigging - Chauvet Batten 80i User Manual

Mounting

Orientation

Rigging

Caution!
Hanging Clamp
Note: sold separately
COLORado™ Batten 80i User Manual
This fixture may be mounted in any safe position.
The fixture includes a mounting yoke to which a rigging clamp can be attached. You
must supply your own clamp and make sure the clamp is capable of supporting the
weight of this fixture. It is recommended to use at least 2 mounting points per
fixture. You can order "C" and "O"-clamps from any CHAUVET dealer or distributor
(CLP-15, CLP-06 recommended).
Note: There are 2 types of applications for this fixture: floor stand for up lighting, and
overhead use for down lighting. If you are using this fixture for up lighting, then you must
use 2 safety cables/chains for each fixture in addition to the mounting brackets.
If hanging the fixture for over head use, then please follow the below steps.
1. Block access below the work area and use suitable and stable platform
when installing or servicing fixture.
2. Safety cables must always be used. The safety cable must be capable of
holding 10 times the weight of the fixture.
3. Verify the structure can hold 10 times the weight of all to-be installed
fixtures.
4. This fixture may be mounting with clamps attached to the mounting bracket,
or attached directly to the fixture, as shown below.
After prolonged periods of operation, the fixture chassis may reach high
temperatures. This fixture must be mounted in a ventilated location, as it is
fan/convection cooled.
Safety Cable (2)
For overhead
hanging purposes.
10
5/19/2008 10:40 AM