Lc5128 Main Output 2, Tone & Talkback - Calrec M3 Operator's Manual

M3
............................................................................................................................... . ...................................................
LC5128 MAIN OUTPUT 2, TONE & TALKBACK
M1
ON AIR
POWER
Direct AFL
Direct PFL
Direct CUT
Direct PAN
Direct Input
Main output Compressor, may be used as a Limiter (50:1 ratio) 20dB Gain reduction, Yellow LEDs.
Normally pre fader can be set POST fader (with button pressed).
RECOVERY AUTO
RECOVERY FAST
ATTACK
Dynamics IN button
RATIO
THRESHOLD
GAIN
TB
TONE
OSCILLATOR FREQUENCY
IDENT button green LED.
TONE button
TONE control
MIC
TB
RTB
EXT 1 & 2 TALKBACK buttons to external destinations
Scribble Strip
INS
ON
PFL
FADER
58
: Routes to Main 1.
: Pushbutton with red LED. Inhibits tone and talkback within the console and
closes relay contact for interface to other areas.
: Red LED flashes to indicate a failure of either the PSU or the fan (if fitted).
: Latching button routes direct input post fader, exclusively to monitor
loudspeaker.
: Latching button routes direct input pre fader signal to small PFL loudspeaker.
: Latching button cuts direct input signal.
: Pans stereo direct input signal.
: Sets signal level, 10dB in hand.
: Sets recovery to between 0.1 to 1.5 secs, programme dependant.
: Changes recovery time from 1 secs to 75ms (overridden by AUTO)
: Normal 4ms @ 5:1 ratio or FAST 0.2ms @ 5:1 ratio.
: Switches in dynamics. Red LED
: 1.5 to 50:1, variable control.
: -20 to +10dBu, variable control.
: Make-up gain adjustable from 0 to +20dB, variable control.
: Talkback momentary button, inoperative ON AIR.
: Latching button, inoperative ON AIR.
: 5 buttons 40, 100, 1k, 10k, 15kHz
: Pulses tone to main outputs only, choice of 4 sequences which
include EBU & BBC GLITS specification (internally selectable).
: Switches ON oscillator, red LED.
: ±10dB level adjustment on nominal 0dBu output.
: Talkback microphone.
: Sets outgoing Talkback level.
: Sets reverse (incoming) Talkback level to PFL loudspeaker.
: Insert button. Selects main output insert (pre fader).
: Green LED. Illuminates when fader is open.
: Latching button routes main output pre fader signal to small PFL
loudspeaker.
: 0dB in hand