Pq5122 Mono Mic/Line Dual Input Channel - Calrec M3 Operator's Manual

M3
............................................................................................................................... . ...................................................

PQ5122 MONO MIC/LINE DUAL INPUT CHANNEL

Routing to
Tone
48V
Ø
I/P2
Gain
Trim
HF Filter
LF Filter
3-band equaliser :
HF shelf
MID bell
LF shelf
EQ in/out button (includes filters) Red LED.
Direct output gain control 10dB in hand.
TB
MM
Aux 4
Aux 1-3
L/R
Scribble strip
ISOL
INS
CUT
AFL
Peak
3 LEDs
ON
FDR
CUE
PFL
Fader
46
: 2 main Stereo outputs up to 4 Mono or Stereo groups.
: Red button switches alignment tone to the channel post mic gain control but pre the
trim - Inhibited on air, but can be internally set to be permanently enabled.
: Microphone phantom power.
: Phase reverse.
: Selects input 2 (mic or line, internal option).
: Rotary Switch +10 to +60dB in 10dB steps (Mic only).
: ± 15dB (applies to both Mic and Line inputs).
: 1 button : 10kHz.
: 2 buttons : 47Hz, 82Hz, both 120Hz.
: ± 15dB at 10kHz or 5kHz (button pressed).
: ± 15dB frequency variable from 250Hz to 4kHz.
: ± 15dB at 60Hz or 160Hz (button pressed).
: Talkback button to direct output.
: Pushbutton selects Mix-Minus buss to either a channel direct output or as a
channel contribution to a common Mix-Minus buss (both the direct o/p and the
MM contribution can be internally selected pre or post fader).
: Stereo output to aux 4 buss, selectable pre or post fader and on/off. Follows
channel pan.
: Mono outputs to aux 1 to 3 busses with individual level, pre/post and on/off
controls.
: Left/right pan selected by PAN button.
: Isolates external VCA control.
: Selects insert circuit (pre or post fader or bypassed are internal options).
: Latching button (Yellow LED) cuts all pre and post signals except insert send (if
selected pre) and PFL.
: Latching button routes channel left/right signal in stereo to the AFL mix which
is fed to the monitor loudspeakers, automatically over-riding the normal feed.
: Red LED illuminates when the signal anywhere in the module is within 3dB of
clipping.
: Displays pre EQ signal level relative to 0dBu.
: Green LED illuminates to show channel fader open.
: Fires remote start/cue when fader is open.
: Fires remote start/cue when pressed, Green LED.
: Latching button routes pre-fader channel signal to the small PFL loudspeaker
(with internal option to inject into the main monitor chain).
: 10dB in hand.